Printable Beagle Camera Mount for Original Prusa Enclosure

These printable files are for a 3D printed mount that replaces the base of the Mintion Beagle Camera. The OEM hardware used for the hinge will still be used for the new mount. It is designed to be mounted in the corner of the Original Prusa Enclosure. However, I'm sure it could be mounted elsewhere.

Additional Parts Needed:

(If you have the Original Prusa Enclosure you should have extras of these)

• M3x40 screw
• M3 Nut

Assembly:

1. Take off Mintion Beagle Camera base.*
2. Print new part (Note: if using included gcode file, it is sliced for a Prusa MK3S using PLA and a 0.4mm nozzle).
3. Insert M3x40 screw from outside of the enclosure and into the new mount on the inside of the enclosure.
4. Attach M3 nut.
5. Re-insert OEM hinge hardware (the rod and screw). Be careful not to over-tighten. Adjust gradually for optimal hinge resistance.

*Mintion Beagle Camera NOT included

ALL 3DApogee designs are protected by Copyright Law. Upon purchase, these files are for personal use for prints. You do NOT have the right to sell any digital files or printed models of my designs without my explicit consent.